Barco MDNC-2221 Guide de l'utilisateur télécharger pdf (Page 23)

5. Advanced operation

4. Select Enabled/Disabled as desired and conﬁrm.

5.7 Hibernate

About hibernate

Enabling hibernation will not only switch off the backlight but will also force the display to disable other

functionalities so that power consumption is further reduced to a minimum. This happens after a speciﬁc

period of time which can be manually adjusted.

Hibernate can only be enabled on your display when the DPMS mode is enabled ﬁrst.

Therefore, please refer to "DPMS mode", page 20 to do this.

To enable/disable hibernation on your display:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Power Management menu.

3. Enter the Hibernate submenu.

4. Select Enabled/Disabled as desired and conﬁrm.

To specify the hibernate timeout:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Power Management menu.

3. Enter the Hibernate Timeout submenu.

4. Set the timeout value as desired and conﬁrm.

5.8 Luminanc e target

About the luminance target

The luminance target of your NIO 2MP LED Display is adjustable over a predeﬁned range. When you

change the luminance target, the display will adjust its backlight to reach the target.

To set the luminance target:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Calibration menu.

3. Enter the Luminance Target submenu.

4. Set a luminance target value as desired and conﬁrm.

The default DICOM calibrated luminance value is available in the technical speciﬁcations

table. The ﬁve year warranty i s v alid for this setting.

K5903058 NIO 2MP LED DISPLAY 17/07/2014 21

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Pas de commentaire

Barco MDNC-2221 Guide de l'utilisateur Page 23