Barco IMAGETILE Instructions d'exploitation télécharger pdf (Page 49)

System manual ImageTile 50

Figure 27

Setting the Resolution of Your ImageTile Display Panel with

DualView Disabled

1. To set the resolution for your ImageTile display panel(s), right click

on the desktop and select “Properties”. Select the “Settings”

tab (see Figure 28 on the next page). Now select the rectangle

that represents the BarcoMed 3MP2FH Imaging Board you are

working with.

SPECIAL NOTE: If you are using the VGA capabilities of your

BarcoMed 3MP2FH Imaging Board, the resolution for that board

will still be set to a VGA resolution of “640 x 480” pixels. If the

BarcoMed 3MP2FH Imaging Board is not running VGA, the device

may not be enabled yet. To enable the device check the “Extend

my Windows desktop onto this monitor” checkbox. Do not click

the “Apply” button at this time.

2. Click on the “Advanced” Button.

3. Select the “Adapter” tab and then click on the “List All Modes…”

button. Select the desired resolution and refresh rate that your

ImageTile display panel supports from the dialog box and click

“OK”.

Note: The resolutions shown will be based on the number of

heads the imaging board supports.

For example: The BarcoMed 3MP2FH Imaging Board

supports two ImageTile display panels. If the resolution of

each display is 1536x2048x256, Windows 2000 will display

the resolution as 3072x2048x256. If necessary you can

change the number of display panels later by using the

Barco Metheus Configuration Tab.

BarcoMed software driver installation

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 134 135

Pas de commentaire

Barco IMAGETILE Instructions d'exploitation Page 49