Barco IMAGETILE Instructions d'exploitation télécharger pdf (Page 106)

System manual ImageTile 107

ENTERING INTERNET PROTOCOL

ADDRESS PROPERTIES

Entering address properties for the first time

Note: When you enter the address properties for the first time, there

is no time limit for entering the address properties.

But if the address properties have already been entered before (which

you cannot distinguish when you start Sentinel Setup), there is a time

limit of 2 minutes for entering the properties.

In that case, follow the procedure described in the following chapter

"Changing the address properties".

Fixed or dynamic IP-addresses?

With the Sentinel Setup software, you can either enter a fixed IP-

address or acquire an IP-address dynamically using the Dynamic

Host Configuration Protocol (DHCP). This is possible when a DHCP

server is available.

Important

We advise to enter a

fixed IP-address. Therefore, ask the network

administrator for a valid IP-address.

If you should use a DHCP server to find an IP-address, there is a

disadvantage: It is possible that the IP-address automatically changes

after some time.

If a user then tries to establish connection with the ImageTile by using

the original IP-address, this will not be possible.

However, this problem can be avoided by linking a host name to

the IP-address.

Moreover, it will be far more convenient for the user to consult the

ImageTile on the web by surfing to a meaningful host name instead of

an IP-address.

For more information, please consult your network administrator.

Sentinel setup

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 134 135

Pas de commentaire

Barco IMAGETILE Instructions d'exploitation Page 106