Barco IMAGETILE Instructions d'exploitation télécharger pdf (Page 35)

System manual ImageTile 36

Installing the BarcoMed Imaging Board

Windows NT 4.0 Display Driver

Installing the Driver Using the BarcoMed Driver Installation

Wizard

SPECIAL NOTE: Prior to installing the BarcoMed Display Drivers you

MUST install the BarcoMed Imaging Board(s), connect the ImageTile

display panel(s) to the card(s) and turn the ImageTile display on.

Refer to the Hardware Installation section of this manual for

instructions on installing the BarcoMed Imaging Board(s) and

connecting them to the ImageTile display panel(s).

To install, reinstall or update the BarcoMed 3MP2FH Imaging Board

Windows NT 4.0 Display Driver, log in using an account with

administrator privileges and follow these steps:

1. Insert your ImageTile Software CD into your computer’s CD drive.

The “BarcoMed Driver Installation Wizard” should start

automatically. If it doesn’t start within 5 minutes, browse the

contents of your ImageTile Software CD and double click on the

file: “NTDriverInstaller.exe” to start the Wizard.

2. Click “Next” on the Wizard’s Welcome Screen to continue or

“Cancel” to exit the Wizard (see figure 4).

Figure 4

If you select “Cancel”, a dialog box (see figure 5) will open asking

you to confirm cancellation of the install process. If you choose

“Yes”, the Wizard will exit. If you choose “No”, the Wizard will

continue normally.

BarcoMed software driver installation

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 134 135

Pas de commentaire

Barco IMAGETILE Instructions d'exploitation Page 35