Barco IMAGETILE Instructions d'exploitation télécharger pdf (Page 100)

System manual ImageTile 101

5. Set the Work Schedule by setting the beginning and ending time of

your work day for each day of the week.

6. Select the screen saver you wish use during the work day in the

“Screen Saver During Work Day” section.

7. Select the amount of time you wish to spend in the Stand-By and

Suspend states after the work day has ended. Please note that

after the time specified has elapsed when you are in Stand-By or

Suspend, you will automatically go into the Off state.

8. Select the amount of time it takes for your monitor to warm up. If

you have a Barco Medical Monitor, select “Barco Quick Start”. If

you are using a non-Barco monitor, select the amount of time it

takes your monitor to warm up via the “Monitor Setting” section.

Contact your monitor vendor for this warm-up time. On Barco

ImageTile displays, the I-GUARD will stabilize the image within a

few seconds after the monitor returns to the active state, thus

eliminating the need for a warm-up period at the beginning of the

work day.

9. If you wish to use this DPMS screen saver as the screen saver at

logon time, check the “Use As Logon Screen Saver” box in the

“Additional Options” section.

10. Save your preferences by pressing the “Save As” button and

entering a new profile name in the “Save Profile Setting” dialog

box.

11. Apply your new scheme by clicking “OK”.

12. Click “OK” again to close the “Display Properties Control Panel”.

Uninstalling DPMS

To remove DPMS screen saver from your system do the following:

For Windows NT 4.0 Systems

1. Launch the Windows Control Panel.

2. Then double click the “Add/Remove Programs Icon”.

3. Highlight “DPMS Screen Saver” in the Dialog Box. Click the

“Add/Remove” button.

4. The Windows Installer will ask if you are sure you want to remove

this program, click “Yes”.

5. When the Windows Installer has finished removing the program,

click “OK” to exit the Add/Remove Program Properties dialog box.

6. Close the “Control Panel” window.

BarcoMed software driver installation

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 134 135

Pas de commentaire

Barco IMAGETILE Instructions d'exploitation Page 100