Barco DC Toolset Manuel d'utilisateur télécharger pdf (Page 75)

A. Recovery a projector with special plug-in

If the code is entered correctly, the Projector Toolset Settings dialog opens otherwise retry this step.

2. Disable Check device type before update (both items must be disabled). (image A-5)

3. Click OK to close the dialog.

4. Click Update now.

An update dialog window opens with the message that the projector is from an unknown type. (im-

age A-6)

5. Click on the combo box and select the correct projector type.

Click OK to continue.

The Update package selection window opens. (image A-7)

6. Select the correct package and click Next.

Note: Using a wrong package can damage the projector completely.

Version information is collected. This operation can take while. (image A-8)

7. If something is checked, uncheck these items (double click to uncheck) and click on Next stage.

8. Uncheck all items by double clicking on the checked items except for item dp80.ClickNext.(imageA-9)

An overview is given of the software to be installed.

9. Click Install.

The selected software will be installed on the projector. This can take a few minutes. Wait until it is

ﬁnished.

When ﬁnished, a reboot message is displayed. Reboot the projector.

10.When the projector is rebooted, click OK. The installation continues and when Installation OK is dis-

played.

Continue now with the update of all other software.

Image A-5

Projector Toolset settings

R59770449 DC TOOLSET 15/12/2009 71

1 2 ... 70 71 72 73 74 75 76 77 78 79

Pas de commentaire

Barco DC Toolset Manuel d'utilisateur Page 75