Barco DC Toolset Manuel d'utilisateur télécharger pdf (Page 48)

5. General device settings Touch panel

5.2 Add a custom lo go in to uch panel

About a custom logo

The touch panel software allows to place a custom logo on the upper left corner of the touch screen. The

software provides an area of 90 x 90 pixels. Any image larger than 90 x 90 pixels will be proportionally

scaled to match inside this area. The ﬁle must be a bitmap ﬁle (bmp, jpeg, jpg, png, ...).

Current active logo

To display the current active logo in DC Toolset, click on Reload.Theﬁle is downloaded from the touch

panel and a preview will be shown within the rectangular square.

Image 5-2

Reload current logo

How to add or change a logo

1. Click on Change... (a). (image 5-3)

The Change customer logo window opens (b).

2. Fill out the path and ﬁle name (c1) and click OK

Or,

click on Load (c2).

A browse window opens (d).

3. Browse to the desired ﬁle (e) a nd click Open (f).

A preview is shown in the Change customer logo window (g). (image 5-4)

4. If this is the ﬁle, click OK (h).

An upload question is displayed (i).

5. Click Yes to upload the image to the touch panel (j).

When the upload is ﬁnished (k), an info window is displayed with the message : New logo is set in touch

panel”.

6. Click OK to continue (l).

R59770449 DC TOOLSET 15/12/2009

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 78 79

Pas de commentaire

Barco DC Toolset Manuel d'utilisateur Page 48