Barco DATA 708 Manuel d'installation télécharger pdf (Page 32)

G2 Adjustment

A-2 5975987A BARCODATA 708 260597

A green LED for each color is mounted on the driver board, below the

CRT's. When selecting the G2 adjustment menu, these green LEDs

must be out. If not, follow the procedure to adjust the G2 :

- Loosen the retaining screws of the upper electronic chassis and

pivot it to the lenses.

- Adjust the G2 potentiometers very slowly with a screwdriver until the

corresponding LED just stops illuminating. Repeat the adjustment

for the other colors.

- Once the three G2 potentiometers have been correctly adjusted,

close the upper electronic chassis and secure with the retaining

screws.

Blue

G2 Adjustments

Green

Red

Loosen screws and move the cover plate

to the left to access the G2 controls.

Cover the G2 controls again after alignment.

Green G2 LED

Picture of the green LED. The other LED's are mounted in the

same neighbourhood.

1 2 ... 27 28 29 30 31 32 33 34

Pas de commentaire

Barco DATA 708 Manuel d'installation Page 32